![]() f Run in foreground, this is suitable for running from init. ![]() d debug level The default is debug level 0 (little debugging), level 1 debugs internal state changes, level 2 debugs events, and level 3 debugs IO calls. Zero, this option has no effect, the Telnet Server standard port (23) is used. p start port TCP base port of servers at terminal server side (defaults: 31000 for Socket server, 30000 for Remote Telnet Server). c close mode Last close handling the default is 0 which means to hangup the modem, 1 means not to hangup. m modem handling The default is 0 which means to check DCD state, 1 means to ignore DCD. The default is to use the RFC2217 protocol. s Use the Socket Server protocol for talking to the server, this means just piping all the data down a TCP connection with no control information, so it's r retries Number of connection request retries before exiting. i retrydelay Delay in seconds between connection requests (default: 60) n netiosize Sets the internal socket I/O size to netiosize (maximum 512 bytes, default 128 bytes) u ptyiosize Sets the internal device I/O size to ptyiosize (maximum 4096 bytes, default 1024 bytes) If 'physport' is assigned to 0, then 'rasname' is used as the IP address on an IP-based serial port addressing.Ĭyclades-ser-cli may be started with the following options: cyclades-ser-cli provides the I/O interface between the device file and the physical port, running as an 'physport' of a Cyclades Terminal Server 'rasname'. ![]() The cyclades-ser-cli program connects a Unix device file 'devname' to a physical port
0 Comments
Leave a Reply. |